Go Back

Eucalyptus and Velvet Ribbon Wreath

You'll Need

  • 3 bunches preserved eucalyptus
  • 1 wire wreath frame, 12 inch
  • Floral wire
  • 2 yards velvet ribbon, 1.5 inch wide

Step by Step

  • Trim the eucalyptus into 5 inch sprigs, keeping a mix of single leaves and small clusters.
  • Wire small bunches to the frame, all facing one direction, overlapping each new bunch over the last.
  • Continue until the frame is fully covered and the leaves lie smooth, not clumped.
  • Tie the velvet ribbon at the top in a loose knot and let both tails hang long.
  • Trim the ribbon ends on an angle for a tidier finish.

Good to Know

Suits: adults and teens.